Share

Maintenance

How to service cup and cone hubs

Pros and cons of Shimano-favoured bearing system; cleaning, inspecting and replacing


Step two: remove and clean/replace the bearings

Remove the bearings for inspection and cleaning, placing the bearings in a box or tray. Greater access can be gained by prising off the dust covers with a small, flat-bladed screwdriver or pick, but Jon’s advice is to leave them in place, unless you are an experienced mechanic and can judge the required force to remove them without damaging the seal.

Grease and grime can be easily removed from bearings with a rag

We’ve used a rear hub for this example, and the bearings shown are ¼”. Front hub bearings in cup and cone systems typically are 3/16”. Typically, nine are used either side. This configuration leaves space for movement of the bearings, which, to the untrained eye, can look like space for a tenth bearing.

Ball bearings are low cost items. Jon recommends replacing them as a matter of course. Different grades are available, however, and those supplied with more expensive hubs tend to be of higher quality and therefore more expensive to replace. Should you choose to retain the bearings, place them on a clean rag, fold the rag over the bearing so they are covered, and agitate to clean.

Share

Newsletter Terms & Conditions

Please enter your email so we can keep you updated with news, features and the latest offers. If you are not interested you can unsubscribe at any time. We will never sell your data and you'll only get messages from us and our partners whose products and services we think you'll enjoy.

Read our full Privacy Policy as well as Terms & Conditions.

production