Share

Maintenance

How to fit a tubeless cycle tyre

Tubeless tyres have been little short of revolutionary in the world of mountain bikes, and their popularity with road cyclists is increasing.

A half-way house between tubular tyres, or ‘tubs’, and traditional ‘clincher’ tyres used with inner tubes, the tubeless tyre is mounted to a compatible rim and filled with sealant.

Tubeless set-ups are claimed to be lighter, and to offer greater puncture resistance at lower pressures than conventional clincher tyres with inner tubes

We seized the opportunity to unite the pair of Schwalbe Ultremo ZX tubeless tyres arrived at RCUK Towers with the Easton EA90 RT aluminium rims supplied with the recently-tested BMC Granfondo GF01.

We’ll report the performance of the new rubber, and its effect on the BMC Granfondo, in a separate article. You can read our first look here. In this article, we’ll examine the process of fitting tubeless tyres to a compatible rim.

Step one – remove the existing tyre

A tyre lever can be used to remove a traditional clincher tyre from a tubeless compatible rim, but don’t use one to fit the tubeless tyre, or you could damage the bead, which is critical to forming an effective seal in the absence of an inner tube.

Use a tyre lever to remove a clincher tyre from a tubeless ready rim, but do not use one to fit the tubeless tyre

What makes a rim tubeless compatible? Look closely, and you’ll see a bead hook. The bead on a tubeless tyre acts as the seal, holding in air and the fluid that rushes to fill any breach in the tread or sidewall.

Step two – fit the valve

Tubeless tyres are supplied with a valve designed specifically for the application. It is secured with a rubber bung on the inside of the rim and allows air into the void between rim and tyre. Tightening the valve ring will help to ensure an air-tight seal.

With no inner tube to hold it in place, the valve is secured with an air-tight bung

Note that the spoke bed on a tubeless compatible rim is not drilled in the manner of a conventional clincher wheel.  This ensures it is sealed against the loss of air or fluid.

Step three – fit the new tyre

Partially fit the new tyre by pulling one side over the sidewall of the rim. As previously mentioned, do not use a tyre lever to do so. Damage to the bead will prevent the tyre from maintaining an effective seal.

Step four – add sealant

With the tyre partially fitted, it’s time to add sealant, which typically is supplied with the tyres.

Sealant should be supplied with tubeless tyres (and was with our Schwalbe Ultremo ZX). We used 40ml in each tyre

We used 40ml of Stan’s No Tubes sealant for each of our Ultremo ZX tubeless tyres. Deposit the contents of the sealant tube inside the tyre at the section closest to the ground.

Step five – complete tyre fitting and inflate

Complete the fitting of the tyre by pulling the opposing sidewall over the rim. To avoid damaging the tyre bead, do not use a tyre lever to complete this process. Schwalbe supply a bead lubricant to aid the process, but we didn’t find it necessary to fit the tyre.

To avoid damaging the bead, fit tubeless tyres by hand and not with a tyre lever

Check the bead is correctly seated and inflate the tyre. Each manufacturer will have a recommended pressure. Schwalbe claim a range of between 70psi and 120psi for the Ultremo ZX tubeless. Once inflated, check again that the bead is seated correctly, and spin the wheel to ensure the sealant is distributed evenly.

Discuss in the forum

Share

Newsletter Terms & Conditions

Please enter your email so we can keep you updated with news, features and the latest offers. If you are not interested you can unsubscribe at any time. We will never sell your data and you'll only get messages from us and our partners whose products and services we think you'll enjoy.

Read our full Privacy Policy as well as Terms & Conditions.

production